







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Roofing for Dallas Homeowners
A Dallas roof takes more punishment than most. Summer afternoons push attic decking past 150°F, then a hailstorm drops golf balls on the same shingles in April, and the clay soil underneath shifts enough to rack the framing. We see the results constantly: granule loss on south-facing slopes, hairline fractures where the deck flexed, and wind-lifted ridge caps on streets from Lakewood to Preston Hollow. Our technicians have up to 19 years of experience reading that damage, and we quote a flat written price before anyone climbs a ladder. Roof repairs in Dallas run $400 – $1,800; full replacements run $8,000 – $20,000. Call Rowan Construction Group Dallas at (833) 954-5327 for a free estimate.
What Our Roofing Service Includes

Roofing is one trade where the difference between a five-year fix and a twenty-five-year roof comes down to what happens under the shingles. We build every scope around the deck, the underlayment, and the flashing, because that is where Dallas leaks actually start.
Roof Repair
Roof repair addresses a defined failure: a torn shingle field, a failed pipe boot, flashing pulled loose at a chimney, or a small section of rotten decking. You need it when a leak is localized and the surrounding shingles still have life left. Rowan Construction Group Dallas isolates the actual failure point with a moisture scan and a visual inspection of the attic side, then quotes the repair as a flat price with the specific materials named.
Roof Replacement & Installation
A roof replacement strips the existing layers down to the deck and installs a new system: underlayment, drip edge, valley flashing, and shingles or tile. You need it when the roof is at the end of its service life, when there are two or more layers already, or when storm damage is widespread enough that patching costs more than replacing. We install GAF and Owens Corning systems in Dallas and document each layer of the assembly with photos before it gets covered.
Metal Roofing
Metal roofing covers standing seam, corrugated panels, and stone-coated steel, all of which handle Dallas hail and heat better than asphalt in most configurations. It makes sense on homes where you plan to stay put and want a service life measured in decades rather than years. Metal roof installation in Dallas runs $15,000 – $40,000 depending on panel type, roof pitch, and the complexity of hips and valleys. Our standing seam work uses concealed fasteners so there are no exposed screws to back out over a Texas summer.
Tile Roofing
Tile roofing means clay barrel tile, concrete tile, or synthetic tile laid over a waterproof underlayment that does the actual sealing. It suits Mediterranean and Spanish Colonial homes common in parts of Dallas, where the tile profile matters to the look of the house. Tile roof repair in Dallas runs $600 – $2,500 for cracked tiles, slipped courses, and failed underlayment at valleys. Barrel tile roofing requires walking the roof on tile-safe boards, and we do that rather than let a crew crack tiles to save time.
Specialty Roofing
Specialty roofing covers low-slope sections, flat-roof tie-ins, modified bitumen, TPO, and the odd geometries that standard shingle work cannot handle. You need it on additions, porch roofs, and any plane under a 3:12 pitch where shingles will not shed water fast enough. We match the membrane to the slope and the drainage path, then detail the transition where the flat section meets the pitched roof, which is where most Dallas flat-roof leaks begin.
Gutters & Accessories
Gutters and accessories include seamless aluminum gutters, downspouts, leaf guards, drip edge, and ridge venting. They matter most in Dallas during the May and October storm windows, when an undersized gutter sends water against the fascia and into the wall. We size gutters to the roof area they drain and pitch them so water actually reaches the downspout instead of pooling at the corner.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Roofing
We work with CGI roofing systems and CWS products on jobs where the homeowner wants a specific manufacturer’s warranty chain, and we know where each one wears first. CGI’s profiles hold up well on the low-slope tie-ins common on Dallas additions, though the sealant at termination bars needs rechecking after a hard freeze. CWS panels we install and repair on homes where wind uplift ratings matter, and we pay attention to the fastener pattern because that is what the rating actually depends on.
On the window and opening side of a roofing job, we coordinate with ES Windows and ECO Window Systems when a roof replacement overlaps with window flashing or a skylight swap, since those transitions are where water gets in. Whether you have CGI, CWS, or any other make on your Dallas roof, we can help.
Signs You Need Roofing Right Now
- Granules in the gutters or at the downspout outlets. Those granules are the UV shield washing off the shingles. Once the asphalt underneath is exposed, the shingle ages years in a single Dallas summer.
- Ceiling stains or brown rings after a storm. A stain means water has already traveled through the deck and insulation. The visible ring is often feet away from the actual entry point, which is why we trace it from the attic side.
- Curling, clawing, or missing shingles on one slope. Usually the south or west face, where heat cycles hardest. Isolated damage is repairable; widespread curling means the shingle field is done.
- Daylight visible through the roof boards in the attic. You should see none. Daylight means a gap in the deck or flashing, and it will let water and pests in on the next storm.
- Sagging along the roofline or a soft spot underfoot. This points to decking that has taken on moisture. It is the one sign worth acting on quickly, because a soft deck turns a repair into a replacement.
Our Roofing Process – Step by Step
- 1
Roof and attic inspection. We walk the roof, photograph every slope, and check the attic side for staining, moisture, and deck condition. A moisture meter confirms whether a suspect area is actually wet or just stained.
- 2
Written scope and flat price. Under Clause 1 of the Haven Standard, you get the price in writing before anyone starts. The scope names the shingle line, the underlayment, the flashing details, and the disposal, so you can compare it line by line against another bid.
- 3
Material delivery and tear-off. We protect the landscaping, strip the old layers, and inspect the deck for soft spots as it comes off. If the deck needs repair, that is a change order you sign before we proceed, not a surprise on the final invoice.
- 4
Installation and photo record. Underlayment, drip edge, valleys, and field shingles go down in sequence, and we photograph each stage. You receive that photo record as a standard deliverable, so you have evidence of what was actually installed.
- 5
Final walk and written warranty. We clean the site with a magnet sweep for nails, walk the roof with you, and hand over the written warranty. The 365-Day Done Right Promise backs the work: if it is not done right, Rowan makes it right.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Roofing Cost in Dallas?

A typical roof replacement in Dallas runs $8,000 – $20,000 depending on roof size, pitch, layer count, and material. A roof repair runs $400 – $1,800 for isolated damage, while a tile roof repair runs $600 – $2,500 and metal roof installation runs $15,000 – $40,000. Those ranges reflect the Dallas market, where hail-rated shingle lines and the labor to install them price differently than they do in flatter parts of the state.
What moves the number: the square footage of the roof surface, how many layers have to come off, the number of hips and valleys that need flashing, and whether the deck needs repair once it is exposed. Steep pitches take longer and cost more. Material choice is the biggest lever, since an impact-rated shingle system costs more upfront but can lower insurance premiums on a Dallas home.
To avoid overpaying, get the quote in writing with the shingle line and underlayment named, and compare bids on scope rather than on the bottom number. A price that is $2,000 lower usually means a lighter underlayment or a skipped ice-and-water shield at the valleys. Every Rowan estimate is free, itemized, and includes a free second opinion on any written estimate you already have. Call (833) 954-5327 for an exact quote.
Roofing Near Dallas – Our Service Area
We serve homeowners across Dallas and the surrounding suburbs, including Garland, Richardson, Plano, Rowlett, Sachse, Murphy, Sunnyvale, Hutchins, and Seagoville. Storm calls in the closer suburbs like Mesquite and Balch Springs get prioritized, and planned replacements are scheduled around the weather window. See the full Dallas service area for coverage details.
Serving Dallas, TX – Our Local Coverage Area
We serve Dallas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Roofing in Dallas

Roofing is the assembly that sheds water off a house: the deck, the underlayment, the flashing, and the shingles or tiles on top. It also covers the gutters and ventilation that move water and heat away from the structure. In Dallas, a complete roofing scope includes hail-rated shingles, valley flashing, and attic ventilation sized to the roof area.
Most Dallas roof replacements take one to three days, weather permitting. A simple gable roof on a single-story home can finish in a day, while a two-story with multiple valleys and dormers runs closer to three. Metal and tile installations take longer than asphalt, often four to six days. We give you the schedule in the written scope so you can plan around it.
Roof replacement in Dallas runs $8,000 – $20,000, roof repair runs $400 – $1,800, and metal roof installation runs $15,000 – $40,000. Tile roof repair runs $600 – $2,500. The range depends on size, pitch, layer count, and material. Call (833) 954-5327 for an exact quote: estimates are free and come in writing.
Yes. We install and repair CGI and CWS roofing systems, including the low-slope tie-ins and termination details where those products are commonly used. We also coordinate flashing at skylights and transitions involving ES Windows and ECO Window Systems. If your roof has a brand we have not named, we can still inspect it and tell you what the repair requires.
Yes. Storm damage is the one roofing situation where speed matters, because a tarp today prevents a ceiling repair next week. After a Dallas hail or wind event, we can get out to inspect the damage and document it for your insurance claim. Calls are answered by a live person 24/7, so you reach someone when the storm hits at night.
Every Rowan roof carries a written workmanship warranty plus the manufacturer’s material warranty, and both are handed over at the final walk. The 365-Day Done Right Promise sits on top: if the work is not done right within a year, Rowan makes it right. The terms are printed on the page and backed by a terms page, not buried in an asterisk.
Move vehicles off the driveway, clear the attic of anything you want protected from dust, and take pictures off the walls near the work area. Expect noise and some vibration during tear-off, and keep pets and kids inside while the crew is on the roof. We do the rest, including the nail sweep at the end and the photo record of the finished installation.
Schedule Your Roofing Service in Dallas Today
Whether you need a leak traced, a full replacement quoted, or a second opinion on a bid you already have, Rowan Construction Group Dallas will put the price in writing before anyone picks up a tool. Every estimate is free, every visit includes a documented photo record, and the 365-Day Done Right Promise backs the work. Call (833) 954-5327 to schedule your free estimate.
Written by the team at Rowan Construction Group.












